Loading...

Airxcel Boat Reverse Air Conditioner SPB05RCBL-F2 | 5000 BTU SeaMach 115V 60Hz

Boat part number 8202408 is a new 5,000 BTUH SeaMach series 60Hz reverse cycle air conditioner from Airxcel, model SPB05RCBL-F2 .
made for Four Winns Boats
$1,299.95 MSRP: $1,754.93
GLS Stock #: 8202408-GG448
Only 2 left
Boat part number 8202408 is a new 5,000 BTUH SeaMach series 60Hz reverse cycle air conditioner from Airxcel, model SPB05RCBL-F2 . Commonly used on Four Winns Boats, part number 065-1929

The SeaMach reverse cycle air conditioner has both a heating and cooling mode of operation. It uses R-22 refrigerant in a conventional vapor compression cycle to transfer heat from the air in the boat to the water. In the cooling mode, a blower blows the cabin air though the indoor or evaporator coil where it is cooled and dehumidified. Liquid refrigerant passing through the evaporator is boiled into a gas by heat removed from the air. The warmed refrigerant gas enters the compressor where its temperature and pressure are increased. The hot refrigerant gas travel to the water coil or condenser where it is cooled by the water and condenses to a liquid. Liquid refrigerant is metered back into the evaporator coil to repeat the process.

In the heating mode, the pressure is reversed. A special reversing valve reverses the flow of the refrigerant throughout the system exchanging the roles of the condenser and evaporator. The refrigerant flows through the water or evaporator coil, picks up heat from the water, and becomes a vapor. The vapor then enters the compressor where it is compressed to a higher temperature. It is then pumped to the indoor coil where the air moving across the coil picks up the heat and the warm air is blown into the room. The compressed refrigerant vapor condenses to a liquid as it gives up heat. Finally, liquid refrigerant flows in the capillary tubes into the indoor coil where the cycle is repeated.

For further information please consult your boat brand dealer or SeaMach.
  • Part Manufacturer: Marvair / Airxcel
  • Series: SeaMach
  • Model: SPB05RCBL-F2
  • Cooling Capacity: 5,000 BTUH
  • System Type: Reverse Cycle
  • Electrical: 115V / 60Hz
  • Refrigerant: R-22
  • Phase: 1
  • Left Hand
  • Controller Type: Electronic Control Board (NOT INCLUDED - Requires a OLED board or the MachAIR board)

Sold as seen in pictures. Customers please note every computer shows colors differently. All measurements are approximate.

Instruction / installation manual included.

Because of the size and/or commodity of this item, we must ship via truckline. The shown freight cost is for the LOWER 48 STATES ONLY and shipped to a business at a commercial address WITH LOADING DOCK. We can ship to your residence, or possibly a nearby terminal. We can also offer international shipping. Please call or email for a shipping quote if needed.

Product Questions

I'm looking at installing this unit in a 26 ft 2006 Sailfish 2660WAC. I know it will fit which is most my problem because I don't have much room. Do you know of a part number for the correct controller? Im assuming I'll need a controller, ducting, water pump and water outlet. Also can you tell me the max current draw? Thank you
Question by: David GERARD McHenry on Nov 12, 2022, 5:16 PM
Hi David,

I would think you'd need a controller, but I'm afraid we don't know which one(s) will work with this unit. We aren't dealers/distributors, and have no way to cross reference the AC components. I had the manual checked, and doesn't list the amp draw. I'm afraid you'd need to check with Marvair directly to get the answers to those two questions. Sorry.

Gene
Answer by: Admin on Nov 14, 2022, 10:27 AM