
Teleflex Boat Gauge Set | Honda Sterling Silver Black Set Of 6
Boat part number 1096184 is a new Sterling silver/black gauge set from Teleflex, part number Unavailable .
made for Custom Applications
$299.95
MSRP: $397.84
GLS Stock #:
1096184-FK700
Only 9 left
Boat part number 1096184 is a new Sterling silver/black gauge set from Teleflex, part number Unavailable .
These illuminated gauges feature a domed lens, silver bezel, black face with silver graphics, and black needles with orange tips. The (2) larger ones measure approximately 3 3/4" Dia. across the face including bezel x 3 1/8" D overall and require a 3 1/4" Dia. cutout. The (4) smaller ones measure approximately 2 1/4" Dia. across the face x 3" and 3 7/8" D, and require a 2" Dia. cutout.
Featured Gauges:
These illuminated gauges feature a domed lens, silver bezel, black face with silver graphics, and black needles with orange tips. The (2) larger ones measure approximately 3 3/4" Dia. across the face including bezel x 3 1/8" D overall and require a 3 1/4" Dia. cutout. The (4) smaller ones measure approximately 2 1/4" Dia. across the face x 3" and 3 7/8" D, and require a 2" Dia. cutout.
Featured Gauges:
- (1) Speedometer | 68306F | Pitot
- (1) Tachometer | 67363F | Threaded Posts | 4/6/8 Cycle 2/3/4/5/6 Pole
- (1) Trim | 67855F | Honda | Threaded Post / Bare Wire
- (1) Fuel | 67021F | Threaded Posts
- (1) Oil | 780818PMFB | 4 Spade Male
- (1) Volt | 67019F | Threaded Posts
- Boat Manufacturer: Unavailable
- Part Manufacturer: Teleflex Marine
- Series: Sterling Silver/Black
- Part Number: Unavailable
- Color: Silver / Black
- Material: Plastic
- Cutout: 3 1/4" Dia. and 2" Dia.
- Connections: Pitot / Threaded Posts 4 Spade Male
- Set up For: Honda
- Tach Set Up For: 4/6/8 Cycle 2/3/4/5/6 Pole
Sold as seen in pictures. Customers please note every computer shows colors differently. All measurements are approximate.
Instruction / installation manual not included.
Hardware not included.
Pigtail connector / harness not included.
Wiring diagram NOT included. You will need to check with a dealer for the proper pin/wiring sequencing.