Tracker Boat Raised Emblem Decal 310324 | Gradient Sticker (Set of 2) - All Questions
Tracker Boat Raised Emblem Decal 310324 | Gradient Sticker (Set of 2)
SKU
8105386
How do I install this decal on my boat?
Question by: Ricky Watts on May 18, 2021, 1:35 PM
Hi Ricky,
The proper way to install this decal would be to clean the hull with an acid base cleaner to remove any grime and wax residue. From there, let the surface dry completely for 24 hours. Next you will want to wipe the area with a clean microfiber cloth in order to remove any last dust particles. You will want to hold the decal up in place and use a light masking tape to secure it in order to check the potential location. Start peeling the backing paper at one end, and slowly start to apply. When completely installed, use a soft plastic squeegee to get rid of all the air bubbles. When the transfer paper is removed, and you see remaining air bubbles, try working them out with your fingers. If they will not come out, use a sharp razor blade to poke a very small hole in order to release the air. Let the adhesive settle for another 24 hours. You are then good to go! Thanks!
Jake
The proper way to install this decal would be to clean the hull with an acid base cleaner to remove any grime and wax residue. From there, let the surface dry completely for 24 hours. Next you will want to wipe the area with a clean microfiber cloth in order to remove any last dust particles. You will want to hold the decal up in place and use a light masking tape to secure it in order to check the potential location. Start peeling the backing paper at one end, and slowly start to apply. When completely installed, use a soft plastic squeegee to get rid of all the air bubbles. When the transfer paper is removed, and you see remaining air bubbles, try working them out with your fingers. If they will not come out, use a sharp razor blade to poke a very small hole in order to release the air. Let the adhesive settle for another 24 hours. You are then good to go! Thanks!
Jake
Answer by: Jake Doro on May 18, 2021, 1:36 PM
I have a 2008 Harris Sunliner and the steering linkage pin has broken and I need to replace it. It’ just below the steering wheel as it enters the console
Question by: Harold Lawrence on Jun 10, 2022, 8:58 AM
Hi Harold,
I'm sorry, but that isn't something we would typically have, and it's not something we can source or order. Chances are you have some sort of Seastar steering system, yes? If so, we'd recommend contacting them directly.
Gene
I'm sorry, but that isn't something we would typically have, and it's not something we can source or order. Chances are you have some sort of Seastar steering system, yes? If so, we'd recommend contacting them directly.
Gene
Answer by: Admin on Jun 10, 2022, 10:48 AM