Triton 1896842 31 Inch Red / White / Black Boat Decals Pair
Boat part number 1026430 is a NEW pair of Triton vinyl boat decals
made for Triton Boats
$39.95 MSRP: $94.43
GLS Stock #: 1026430-BF395
103 in stock
Boat part number 1026430 is a NEW pair of Triton vinyl boat decals. Triton part #1896842.
Features:
- Colors are white, black and red.
- Each decal measures approximately 31" long X 5 1/4" high overall.
Sold as seen in pictures. Customers please note every computer shows colors differently. All measurements are approximate.
Product Questions
Do these decals come with install instructions ? or could you send ?
Question by: Joe R Baker on Aug 31, 2022, 12:42 PM
Hi Joe,
There aren't any manufacturer instructions with them, but we do send this generic message with them:
Surfaces must be thoroughly cleaned before applying graphics or pinstripe.
Instructions:
Fiberglass Hulls:
Remove any dried matter (tape or glue) with a single edge razor blade. Thoroughly wipe surface clean with hot soapy water. This may take a number of passes depending on the surface condition. Rinse with clear warm water. DO NOT USE ANY ALCOHOL BASED PRODUCTS. Allow to dry for 72 hours in 50-90 degree heat. Wipe with lint free cloth.
Aluminum or Metal:
Remove any dried matter (tape or glue) with a single edge razor blade. Surface can be cleaned with a solvent such as Xylol or Lacquer thinner. Allow to dry for 72 hours in 50-90 degree heat. Wipe with lint free cloth.
There are a number of ways to apply decals and pinstripe. It comes down to personal preference. We highly recommend searching the web (youtube has several videos) for decal application. We also HIGHLY recommend cutting a 6" section off the pinstripe to test before applying the whole roll.
Hope this helps.
Gene
There aren't any manufacturer instructions with them, but we do send this generic message with them:
Surfaces must be thoroughly cleaned before applying graphics or pinstripe.
Instructions:
Fiberglass Hulls:
Remove any dried matter (tape or glue) with a single edge razor blade. Thoroughly wipe surface clean with hot soapy water. This may take a number of passes depending on the surface condition. Rinse with clear warm water. DO NOT USE ANY ALCOHOL BASED PRODUCTS. Allow to dry for 72 hours in 50-90 degree heat. Wipe with lint free cloth.
Aluminum or Metal:
Remove any dried matter (tape or glue) with a single edge razor blade. Surface can be cleaned with a solvent such as Xylol or Lacquer thinner. Allow to dry for 72 hours in 50-90 degree heat. Wipe with lint free cloth.
There are a number of ways to apply decals and pinstripe. It comes down to personal preference. We highly recommend searching the web (youtube has several videos) for decal application. We also HIGHLY recommend cutting a 6" section off the pinstripe to test before applying the whole roll.
Hope this helps.
Gene
Answer by: Admin on Aug 31, 2022, 1:05 PM
Will these work on leather seat back and leather on front of console?
Question by: Jackie Switzer on Jul 25, 2022, 5:18 PM
Hi Jackie,
We sure don't know why they wouldn't. You may need to roughen the surface though.
Gene
We sure don't know why they wouldn't. You may need to roughen the surface though.
Gene
Answer by: Admin on Jul 26, 2022, 11:23 AM