BRP Evinrude Boat Speedometer Gauge 765467 | Icon Basic 3 1/4 Inch - All Questions
BRP Evinrude Boat Speedometer Gauge 765467 | Icon Basic 3 1/4 Inch
SKU
1081795
I had just bought this speedo, what I did not see when I sent the order was the 2 pig tails were not included. I had a electrical wire issue in my older Lund, bought a low hour 2011 Evinrude 150 H.O. I went to all new Evinrude engine harness #176340 volt, trim fuel tach and your speedo I have no help from our Evinrude dealer as trying to figure this out. The wire harness they sent is not the right one, wrongs gauge end plugs,
CAN YOU HELP ME OUT
BEST TO CALL ME DIRECT 605-390-9001 jim
CAN YOU HELP ME OUT
BEST TO CALL ME DIRECT 605-390-9001 jim
Question by: JIM GLINES on May 18, 2021, 9:38 AM
Hello Jim,
We do have a deutsch connector that will work with that gauge (see link below) but you'd need to move the wires inside it around a bit (it's really self explanatory once you have one in your hand. You should only need the one 12 pin/8 wire connector. That other 6 pin connection on the back isn't typically used. What we can't tell you though is the wiring sequence. We aren't BRP dealers/distributors and these came with no instructions or diagrams.
Here is a link to that connector:
link: https://www.greatlakesskipper.com/deutsch-12-pin-8-wire-female-boat-gauge-connector
Hope this helps!
Gene
We do have a deutsch connector that will work with that gauge (see link below) but you'd need to move the wires inside it around a bit (it's really self explanatory once you have one in your hand. You should only need the one 12 pin/8 wire connector. That other 6 pin connection on the back isn't typically used. What we can't tell you though is the wiring sequence. We aren't BRP dealers/distributors and these came with no instructions or diagrams.
Here is a link to that connector:
link: https://www.greatlakesskipper.com/deutsch-12-pin-8-wire-female-boat-gauge-connector
Hope this helps!
Gene
Answer by: Gene Warmuth on May 19, 2021, 11:10 AM