Four Winns Boat Raised Decal 055-2717 | Vista 348 Gold Silver Blue - All Questions
Four Winns Boat Raised Decal 055-2717 | Vista 348 Gold Silver Blue
SKU
8200890
Hello to whoever responds to this message. I have seen everything it seems, but the VISTA 268 badge / raised decal. Please advise on where I can get it. Thanks in advance.
Question by: Carl Henderson on Jan 31, 2021, 8:37 AM
Hi Carl,
I'm afraid we sold out of the Vista 268 decal quite some time ago and don't know when/if we will see more. They aren't something we can source or order. If it helps the Four Winns part number for that was 055-2667.
Sorry we could not help.
Gene
I'm afraid we sold out of the Vista 268 decal quite some time ago and don't know when/if we will see more. They aren't something we can source or order. If it helps the Four Winns part number for that was 055-2667.
Sorry we could not help.
Gene
Answer by: Gene Warmuth on Jan 31, 2021, 12:00 PM
How do I install this decal on my boat?
Question by: Ricky Watts on May 18, 2021, 1:35 PM
Hi Ricky,
The proper way to install this decal would be to clean the hull with an acid base cleaner to remove any grime and wax residue. From there, let the surface dry completely for 24 hours. Next you will want to wipe the area with a clean microfiber cloth in order to remove any last dust particles. You will want to hold the decal up in place and use a light masking tape to secure it in order to check the potential location. Start peeling the backing paper at one end, and slowly start to apply. When completely installed, use a soft plastic squeegee to get rid of all the air bubbles. When the transfer paper is removed, and you see remaining air bubbles, try working them out with your fingers. If they will not come out, use a sharp razor blade to poke a very small hole in order to release the air. Let the adhesive settle for another 24 hours. You are then good to go! Thanks!
Jake
The proper way to install this decal would be to clean the hull with an acid base cleaner to remove any grime and wax residue. From there, let the surface dry completely for 24 hours. Next you will want to wipe the area with a clean microfiber cloth in order to remove any last dust particles. You will want to hold the decal up in place and use a light masking tape to secure it in order to check the potential location. Start peeling the backing paper at one end, and slowly start to apply. When completely installed, use a soft plastic squeegee to get rid of all the air bubbles. When the transfer paper is removed, and you see remaining air bubbles, try working them out with your fingers. If they will not come out, use a sharp razor blade to poke a very small hole in order to release the air. Let the adhesive settle for another 24 hours. You are then good to go! Thanks!
Jake
Answer by: Jake Doro on May 18, 2021, 1:36 PM