Larson Boat Graphic Decals 8634-2074 | Senza Black Gunmetal (4PC) - All Questions
Larson Boat Graphic Decals 8634-2074 | Senza Black Gunmetal (4PC)
SKU
8600489
Does this decal fit the 2007 Larson senza 206?
Question by: Stephane MENARD on Mar 2, 2021, 2:23 PM
Hello Stephane,
I'm afraid we have no way to cross reference the decal to specific boats. You see, we aren't dealers/distributors - we purchase overstock and excess marine accessories. You'd pretty much need to either contact a dealer and give them the Larson part number - 8634-2074 - or just go by the measurements in the ad.
Sorry we could not help.
Gene
I'm afraid we have no way to cross reference the decal to specific boats. You see, we aren't dealers/distributors - we purchase overstock and excess marine accessories. You'd pretty much need to either contact a dealer and give them the Larson part number - 8634-2074 - or just go by the measurements in the ad.
Sorry we could not help.
Gene
Answer by: Gene Warmuth on Mar 2, 2021, 3:12 PM
How do I install this decal on my boat?
Question by: Ricky Watts on May 18, 2021, 1:35 PM
Hi Ricky,
The proper way to install this decal would be to clean the hull with an acid base cleaner to remove any grime and wax residue. From there, let the surface dry completely for 24 hours. Next you will want to wipe the area with a clean microfiber cloth in order to remove any last dust particles. You will want to hold the decal up in place and use a light masking tape to secure it in order to check the potential location. Start peeling the backing paper at one end, and slowly start to apply. When completely installed, use a soft plastic squeegee to get rid of all the air bubbles. When the transfer paper is removed, and you see remaining air bubbles, try working them out with your fingers. If they will not come out, use a sharp razor blade to poke a very small hole in order to release the air. Let the adhesive settle for another 24 hours. You are then good to go! Thanks!
Jake
The proper way to install this decal would be to clean the hull with an acid base cleaner to remove any grime and wax residue. From there, let the surface dry completely for 24 hours. Next you will want to wipe the area with a clean microfiber cloth in order to remove any last dust particles. You will want to hold the decal up in place and use a light masking tape to secure it in order to check the potential location. Start peeling the backing paper at one end, and slowly start to apply. When completely installed, use a soft plastic squeegee to get rid of all the air bubbles. When the transfer paper is removed, and you see remaining air bubbles, try working them out with your fingers. If they will not come out, use a sharp razor blade to poke a very small hole in order to release the air. Let the adhesive settle for another 24 hours. You are then good to go! Thanks!
Jake
Answer by: Jake Doro on May 18, 2021, 1:36 PM